Bafang BBS power cable for extension or conversion.

The connector can be BBS01/02 default bullet connector, BBSHD Anderson connector, Amass XT60 connector, Amass XT90 connector.

Cable length could be 10-100cm for your demand;

Wre: 12AWG black/red wire;

If your current Bafang motor and the battery are with different connector, then you may need a conversion cable.

If your ebike battery power cable is too short, then you may need a extension cable. 

Hailong case discharging connector 4 blade contacts, 5 round contacts or 6 round contacts, fit for Hailong 01, Hailong 02 or Hailong 03 casing battery.  Please note They are not suitable for Hailong 01 Pro battery; the hailong 01 Pro case use 5 blade contacts connector al though the housing is similar but not compatible.

There are 3 types of connectors for Hailong case, the outter dimensions are the same, only the contacts are different, one is with 4 blade contacts, one is with 5 golden round contacts and the rest is with 6 round coontacts. Please check your own Hailong connectors before placing the order.

20A< 4 pin connector<25A; 25A <5 pin connector <30A; 

 30A < 6 pin connector <35A;

e-bike motor hall connector DJ7061A-2.8-11/21 male/female plug; this plug is normally used for motor hall, ebike brake, e bike gas/throttle end connection.

6P plug for motor hall;

3P plug for e-bike throttle/gas;

2P plug for e-brake;

Plug sping and male tab are included.

E-bike power cord for connecting motor controller to ebike battery.

For connecting motor controller side, the connector could be DJ7031 connector(we no longer use it) , Φ4mm bullet connector(default power connector of our front or rear ebike controllers) or Φ5mm bullet connector(default power connector for Bafang BBS01/02 kit).

For connecting battery side, you can choose your demand connectors.

Currently, 90% front or rear brushless motor controller use Φ4mm bullet connectors for motor controller. You can check your own controller power connectors before ordering.

Default cable would be 14AWG.

If you need 12AWG wire for the power cable, please leave a message.