E-bike rear light 6V LED

1. Input: DC 6V-60V

2. Output: 6V

3. Power: 0.6W

4 It can be powered by your ebike battery from 6V to 60V;

5. Cable length:  1.5M

6. You may need an ON/OFF switch to control the rear light;

7. This rear light can be mounted on the bike rear rack or on the seatpost tube. We will provide the matching backet.

8. If you also need a ebike headlight, you can order on our website, we can solder the rear light and head light to be controlled by one on/off switch.

KT-V12L Kunteng Dual hall 12 poles, 12 magnets pedal assisting sensor for ebike; it is easy to install on left side of the BB.

Cable length: 80cm 

Cable connection: 

Brown wire ---> +5v

Black wire---> Negative Electrode

Yellow wire ---> Signal

Note: This PAS only work with KT controller. Also,Kunteng controller normally set C1 = 2 as a defaullt setting for the 8 pole PAS, if you want to use 12 poles PAS, please set C1 =6 via the display, otherwise the PAS may not work.

Fatbike motor cable for Bafang 750W RM G06 snow bike hub motor.

The female cable length is 80cm, the phase wire adapts Φ5 BBS bullet connector which can bear larger current.

The extension cable length is 110cm.

Split 12 magnets dual hall sensor with higher accuracy for electric bikes. It is easy to install with the split PAS. No need to remove the crank; Only plug the split magnets arount the bottom bracket axle, then fix the sensor on the seat tube.

The PAS fits our KT series controllers.