Power cable for Dorado battery, Tigershark case, Atlas case or other Reention casing battery with PLA 0273 male connector , 5 pin PLA 0049 or 6 pin PLA 0238 connector; If you order the power cable, it is better for you to choose Ø4mm bullet connector, Ø5mm bullet connector or bare wire for the end connector for controller/motor because there is a small wire rubber O seal on the mounting, other connectors would be too big to go though the wire seal(you may need to let the wire go through the wire O seal, then solder the larger connectors). The connector is soldered with cable which you can replace your old plug on the battery easily by removing the lock screw.

If you need a extension cable or conversion wire for your battery, then the big connector is not a problem. But please make sure you choose the right male or female connector when placing the order.

This power cable is suitable for the Atlas casing battery, 36V Dorado battery, 48V Dorado batteries or the Tigershark casing battery. 

The 2 pin PLA 0273 connector is the male connector(installed in the battery mounting base), it's matching 2 pin female connector is PLA 0274 connector which is installed on the battery body;  Note, the PLA 0274 looks like 5 pin connector, but the three small pins are empty, therefore we call it "2 pin" connector.

The 5 pin PLA 0049 connector is the male connector(installed in the battery mounting base), it's matching 5 pin female connector is PLA 0050 connector which is installed on the battery body;

The 6 pin PLA 0238 connector is the male connector(installed in the battery mounting base), it's matching 6 pin female connector is PLA 0239 connector which is installed on the battery body;

The default wires are 12 AWG wire, if you need 10AWG wire, please email us separately. By the way, 10AWG wire for power cable, they may be too large for the wire seal of the mounting unless you discard the wire seal when installing the power cable.

Dual battery converter with wide DC input 24V -72V. 

Output: DC 24V -72V, max 30A or 40A current. 

Input with XT60 male connector; output with XT60 female connector. 

If you have two batteries(24V-72V),  you want to use the two batteries with one ebike, then you can connect the two batteries with the dual battery converter.  

When you are going to charge the battery, please switch one of the batteries first before charging because the dual battery converter only protect the two batteries discharging; it has no protection for simultaneous charging.