E-bike power cord for connecting motor controller to ebike battery.

For connecting motor controller side, the connector could be DJ7031 connector(we no longer use it) , Φ4mm bullet connector(default power connector of our front or rear ebike controllers) or Φ5mm bullet connector(default power connector for Bafang BBS01/02 kit).

For connecting battery side, you can choose your demand connectors.

Currently, 90% front or rear brushless motor controller use Φ4mm bullet connectors for motor controller. You can check your own controller power connectors before ordering.

Default cable would be 14AWG.

If you need 12AWG wire for the power cable, please leave a message.

Ebike brushless hub motor torque washers;12mm diameter with a flat of 10mm

Motor cable with 9 pin waterproof connector, male and female; male cable length 0.4m; female cable length: 85cm, 100cm or 150cm for option

If you order the female part, please also choose the motor hall connectors; if you don't choose the motor hall connectors, we will ship with the connector randomly.

If you don't know which connectors to choose, you can check our controllers, our controllers use the 6P DJ7061 connectors and 2.8pins for motor hall as default.

If you need longer wire for the motor, you can add a 9pin extension motor wire for your motor.

Engine opening tool for bafang bldc hub motors, such as SWXK, SWXK5, BPM2 etc 4 slots motor cover. 

Ebike brushless hub motor spare parts, washers, nuts etc., end plastic cap, or Bafang rear hub motor freewheel spacer.

Bafang BBS01/BBS02 Secondary Reduction Metal Gear/Chainring Gear;

If the teeth which engages the pawl clutch is worn, then you can order this reduction gear to replace it.

Note: This reduction gear is only fit for BBS01 or BBS02, it isnot suitable for BBSHD kit.

Bafang BBSHD 48V 1000W Pedal assisting Magnet ring disc;

Note: This magnet ring is not suitable for BBS01 or BBS02 kit; it's only suitable for BBSHD kit.

Bafang BBSHD axle rubber seal for replacement.

If you open your BBSHD, then you may need to break the crank shaft rubber seal.

Bafang BBS /UART M620 /UART M400 motor programming USB cable; Cable length: 45mm

If you want to change parameter of your bbs controller, you can use this programming cable.  If you want to know what parameter you can change, please see the pictures on our website. 

Please note: Making changes to your original motor/controller software may void warranty of your motor/controller. Improper changes may cause damage of your battery or motor, please do a little research on the internet before programming.

If you need the software for programming the BBS, please click here: Bafang system programming 

If the software does not work, please click the latest version: BBS programming 2020 version