E-Bike Kit
-
E-bike brushless hub motor anti-torque washers
Ebike brushless hub motor torque washers;12mm diameter with a flat of 10mm
-
Bafang bldc hub engines(SWXK/BPM2 etc) opening spanner
Engine opening tool for bafang bldc hub motors, such as SWXK, SWXK5, BPM2 etc 4 slots motor cover.
-
Bafang BBS01/BBS02 Secondary Reduction Metal Gear/Chainring Gear
Bafang BBS01/BBS02 Secondary Reduction Metal Gear/Chainring Gear;
If the teeth which engages the pawl clutch is worn, then you can order this reduction gear to replace it.
Note: This reduction gear is only fit for BBS01 or BBS02, it isnot suitable for BBSHD kit.
-
Bafang BBSHD PAS magnet disc ring for replacement
Bafang BBSHD 48V 1000W Pedal assisting Magnet ring disc;
Note: This magnet ring is not suitable for BBS01 or BBS02 kit; it's only suitable for BBSHD kit.
-
Bafang BBSHD / BBS03 axle shaft rubber seal
Bafang BBSHD axle rubber seal for replacement.
If you open your BBSHD, then you may need to break the crank shaft rubber seal.
-
BBSHD gasket for motor core
BBSHD gasket for Bafang HD stator or BBSHD motor core.
-
Bafang BBS01 BBS02 wire rubber seals for bbs motor phase
Bafang BBS01 BBS02 wire rubber seals for bbs motor phase, the price includes 3pcs rubber seals because one bbs motor has three motor phase wires.
Note: these seals don't fit for BBSHD motor phase wires.
-
Bafang BBSHD pawl clutch/ pedal freewheel
BBSHD pawl clutch for replacement. If your BBSHD could not pedal smoothly, it could be that the BBSHD freewheel have problem.
-
Bafang BBS01 /BBS02/ AEG PAS Magnet Disc Ring
Bafang/8FUN BBS01/BBS02 PAS magnet disc ring for replacement. This magnet cannot fit for BBSHD, please note.
If you need the BBS PAS circuit for repair, please click here: BBS PAS circuit
There is a C clip ring to fastern the magnet disc, if you need the plier to remove the clip ring, please click here: plier for C clip ring
-
BBS hall gomet sealing/BBSHD hall wire rubber seal
BBS hall gomet sealing;
BBS01/BBS02 hall sensor wire rubber gasket;
BBSHD hall wire rubber seal;
When you open the motor to replace the motor stator, or HD rotor, you may ruin the hall sensor wire gomet, therefore you may need a new wire ruber seal for the bbs.
BBS01, BB0S2 and BBSHD use the same hall wire rubber seal.