Bafang Ultra M620 G510 barebone motor, no accessories.

48V or 52 1000w for option;

The Ultra M620 motor has two protocols, UART or CAN, you need to check your own display connector or your original motor's protocol first. If the display is with a round connector, it will be UART protocol, if the display is with a triangle disconnector, then your system will be with CAN protocol.  If you don't know how to check, you can check the EB-BUS(1T4 main harness), whether the display connector is round or triangle. We have both EB-BUS for your reference: Ultra M620 EB-BUS 

The display and the controller need to be the same protocol, then the system can work, otherwise, the system will not work.

Bafang Ultra Motor M620 /G510 kit 48V 1000W or 52V 1000W.  If you need frames for the M620 motors, please email us, we have alloy or carbon fibre frames for the Ultra motors.

Our UART motors are with upgraded rotor and third gear which enable the motor quieter. The new rotor and gear are originally designed for M630 1500W motor which is an upgrade for M620 motor.

This motor has two protocols, CAN and UART. CAN protocol is with 5 pin triangle display connector while UART is with 5 pin round display connector.

Packling list for the Ultra M620 kit:

1. Bafang motor Ultra G510;

2. EB-BUS 1T4 cable;

3. Chainwheel: different for MTB or fatbike;

4. Crank arms: different for MTB or fatbike;

5. DPC18 color display;

6. Speed sensor;

7. Headlight and taillight cables;

8. Power cable;

9. Plastic cover;

10. Installation screws;

11. Alloy hanger(optional): if you already have the hanger built with your bike, then you don't need to buy the hanger.

Bafang Ultra M620 G510 motor torque sensor /torsion sensor for replacement;

Bafang Ultra M620 torque sensor with axle for repair. There are two types of M620 torque sensor, CAN protocol and UART protocol, please check your motor protocol before ordering. The CAN protocol motor needs re-calibration by the Besst tool after replacing the torque sensor or controller, please note. If you don't have Besst too access, please don't order the CAN torque sensor.

If you don't know how to check your M620 motor protocol, please check from the display's connector: DP C18 display

How how to replace the M620 torque sensor, please check the video below:

Bafang Ultra G510 M620 motor controller for replacement;

M620 Ultra motor controller for high power e-bikes.

Bafang Ultra controller 48V or 52V for replacement. 

There are two types of M620 torque sensor, CAN protocol and UART protocol, please check your motor protocol before ordering. The CAN protocol motor needs recalibration by the Besst tool after replacing the controller or the torque sensor, please note. If you don't have Besst tool access, please don't order the CANbus controller. If you ordered the controller board, you can use your original case and harness, if you don't know how to install the controller board, we have video for it; it's about a 5-10 minutes job, no soldering for the controller board.

If you don't know how to check your M620 motor protocol, please check from the display's connector: DP C18 display

Note: Some  UART motors may need calibration after replacing the controller. If you don't know how to calibrate the controller manually, you can order a Bafang M620 calibration display(Only for UART) together with the controller.

How to classify UART or CAN protocol for your M620 motor? Please check the connector of the display,  UART protocol motor is with round connector while CAN protocol motor is with triangle display connector. 

For how to calibrate the motor, please check video below: