Accessories
-
e-bike rear light/ 6V LED bike taillight(powered by battery or controller)
E-bike rear light 6V LED
1. Input: DC 6V-60V
2. Output: 6V
3. Power: 0.6W
4 It can be powered by your ebike battery from 6V to 60V;
5. Cable length: 1.5M
6. You may need an ON/OFF switch to control the rear light;
7. This rear light can be mounted on the bike rear rack or on the seatpost tube. We will provide the matching backet.
8. If you also need a ebike headlight, you can order on our website, we can solder the rear light and head light to be controlled by one on/off switch.
-
KT-V12L Kunteng Dual hall 12 poles, 12 magnets pedal assisting sensor
KT-V12L Kunteng Dual hall 12 poles, 12 magnets pedal assisting sensor for ebike; it is easy to install on left side of the BB.
Cable length: 80cm
Cable connection:
Brown wire ---> +5v
Black wire---> Negative Electrode
Yellow wire ---> Signal
Note: This PAS only work with KT controller. Also,Kunteng controller normally set C1 = 2 as a defaullt setting for the 8 pole PAS, if you want to use 12 poles PAS, please set C1 =6 via the display, otherwise the PAS may not work.
-
Motor cable for Bafang 750W fatbike/ snow bike hub motor
Fatbike motor cable for Bafang 750W RM G06 snow bike hub motor.
The female cable length is 80cm, the phase wire adapts Φ5 BBS bullet connector which can bear larger current.
The extension cable length is 110cm.
-
e-bike 12 poles dual hall pedelec sensor-split sensor(PAS) for easy installation
Split 12 magnets dual hall sensor with higher accuracy for electric bikes. It is easy to install with the split PAS. No need to remove the crank; Only plug the split magnets arount the bottom bracket axle, then fix the sensor on the seat tube.
The PAS fits our KT series controllers.
-
Bicycle B B axle wrench tools
Bicycle b b axle wrench tools for assembling E-bike PAS. -
E-bike hub motor spare parts
Ebike brushless hub motor spare parts, washers, nuts etc., end plastic cap, or Bafang rear hub motor freewheel spacer.
-
$3.00 As low as: $2.80
Controller case for 250W 6 mosfets controller-GBK-CON611, CON621, CON63 or CON94 controller
ABS controller case for ebike controller;
Small case is suitable for 250W controller-GBK-CON611, CON621 or CON63, can be mounted on the frame of bicycle;
Larger case is suitable for CON94 350W controller, can be mounted on ebike frame;
-
Wuxing Two Switch with horn switch/light switch
Wuxing Two Switch with horn switch and light switch; cable length 1.5m -
Hidden wire brake sensor/HWBS for electric bicycle without using the normal e-brake lever
Hidden wire brake sensor can use normal brake, without the use of special brake lever. Sensor installed on the soft shaft of the brake, detection the movement of brake lines online. HWBS is a long life, small volume, free maintenance, micro-consumption electronic, low voltage power supply, non-contact detection of magnetic sensors. Internal PLL circuit can ensure the stable output even use in vibration situations. -
Electric bicycle spoke wrenches
Bicycle spoke wrenches suitable for different spoke specification.