E-bike 6V LED headlight suitable for Bafang BBS. Input: AC6V ; Cable length: 1.5M

Connector matching for Bafang BBS01/BBS02B controller's headlight plug, red wire for positive, blue wire for negative.

DPC18 display has a "headlight" button; for 965 and 961 display, press "+" button and hold for 3 seconds, the headlight will switch on/off.

If you use it for Ultra M620 mid motor, Bafang M400 motor, M420 or Bafang M300 motor, this 6V LED headlight will also be suitable for these mid drive motors. Please make sure you have the Bafang motor light connection cable.

Ebike rear light/taillight for safety biking. 6V LED with small power consumption for your ebike. 

If your bike has no rear rack to install the taillight, you can install the taillight on the seatpost tube, and we will provide you with the mounting bracket. 

The rear light is AC 6V input and you can connect to your Bafang mid motor directly, such as BBS, Max drive M400, M420,M300, Ultra M620 motor which has 6V light leads. If your motor is M620, MM420, M400 or M300, please make sure you have the motor light cable for connecting the front light or tail light.  The connector for the BBS01/BBS02, M620, M400, M420, M300 light is called 4.8 pins; for BBSHD light leads, there are two versions, at the beginning, BBSHD uses 2 pins SM connector for lights, later Bafang change to 4.8mm pins for BBSHD lights(they are going to use the same connector for all the Bafang motor lights), therefore, please double check your BBSHD light leads before ordering the light for your BBSHD motor.

If you prefer to power the rear light by the battery directly, we also have another tail light which can be used with DC6V to 60V batteries.

If you are going to use the rear light for Bafang Max drive or Ultra M620 mid motor, this rear light will also be suitable for them.

If your original bafang BBS motor has only a pair of light cables, while you want to connect both front light and taillight for your bike, then you can choose a Y cable for the light.

Bafang bbs01/bbs02/bbshd /Ulra M620/Max drive M400 /M500/M600/M420  left hand thumb throttle with Wuxing throttle and Higo connector. Cable length: 48cm.

Note: This throttle also fit for Bafang Max Drive M400 G330 motor, but you need to change to a 1T4 EB-BUS, otherwise you cannot connect the throttle to your Max drive unit.